-----------------------------------------------------------------------
                  INSTALLING THE ISOLAN PC-NFS DRIVER
-----------------------------------------------------------------------
                               --------
                               CONTENTS
                               --------

  INTRODUCTION...........................................Page 2
    Before You Begin.....................................Page 2
    The Controller Cards.................................Page 3
  INSTALLING THE PC-NFS DRIVER...........................Page 4
    Introduction.........................................Page 4
    Installing The PC-NFS Driver.........................Page 5







                               -Page 1-

                             ------------
                             INTRODUCTION
                             ------------

  This section of the manual gives instructions for installing:
   the PC-NFS Driver
  Please note that this manual does not contain all instructions
  for the installation of the PC-NFS Driver and, where necessary
  you will be referred to the appropriate section of the PC-NFS manual.


BEFORE YOU BEGIN
  Before you start installation, we recommend that you make working
  copies of the master diskettes supplied with your PC-NFS application
  software. Use the DOS `diskcopy' command as described in your DOS
  reference manual. Store the master diskettes in a safe place and use
  your working copy for the installation.
  All further references to the PC-NFS Diskettes will assume that your
  working copies are being used.

                               -Page 2-

THE CONTROLLER CARDS
  Make sure you have carried out the following actions before you
  commence the PC-NFS installation; they apply to installations with
  all types of ISOLAN Controller Cards.
     Ensure that there are no Interrupt, Address or DMA conflicts
      with other devices in the computer in which the Controller
      Card is to be installed. Refer to the Installation Manual
      that is packaged with your Controller Card.
     Check all cabling after hardware installation.











                               -Page 3-

                     ----------------------------
                     INSTALLING THE PC-NFS DRIVER
                     ----------------------------


INTRODUCTION
  The PC-NFS driver (MBICCNFS) supports all ISOLAN Controller Cards
  of the AT and MCA type. It does not support the ISOLAN PC
  Controller Cards.
  PC-NFS allows a PC to make use of disk and printer resources
  on an NFS Server.










                               -Page 4-

INSTALLING THE PC-NFS DRIVER

  1.    When installing the PC-NFS driver copy the files to an
        appropriate directory on your hard disk.

        For example, type:

            MD  C:\NFS

        type:

            C:
            CD  \NFS

        type:

            COPY A:\NFS\*.*

        The driver files are now copied to a sub-directory called NFS
        (you will require this information in Step 3).


  2.    Run the SUN Microsystems PC-NFS install utility following the
        instructions in the PC-NFS Installation Guide. During
        installation, a screen will appear which will prompt for the
        driver (Ethernet Adapter) to be entered.
        Select `Other'.

  3.    Once you have selected `Other' a new screen will be displayed.
        This screen will ask you to enter a line in CONFIG.SYS.
        The prompt will ask you to enter a line of the form:

            DEVICE = pathname

        Type:

            DEVICE = C:\NFS\MBICCNFS.SYS

  The pathname you have entered in Step 3 will be added to your
  CONFIG.SYS file.
  Once Step 3 is completed, continue with the PC-NFS installation as
  described in the PC-NFS Installation Guide.


                               -Page 5-
